[DENSO WAVE INCORPORATED] Robot Controller Connection(GP4000 Series)


You can connect GP4000 Series to a motor driver to operate and surveil a motor.



Supported Connection Devices

ManufacturerSupported Model

Target HMI

Related UnitsGP4000 Series
ResolutionQVGA (320 x 240 pixels)
Related ModelsGP-4301T
  • GP-Pro EX Ver. 3.50.000 or higher is required.
  • GP-4301T, GP3300 (Except monochrome models) or LT-3300S support this functionality.
  • Please download the  b-CAP Protocol (TCP) Driver (Ver.1.15.14 or later) from our website.
  • We do not guarantee that the operation of this sample will be uninterrupted or error-free.
  • The PDF file of an explanatory material is also compressed into this file.

*1 This Models is available by making changes to the backup device and the holding area to the internal variable model change.


  • You can check a state of the controller.
  • A list and a running state of programs registered in the controller are displayed.
  • You can monitor input/output signals. (Forced Set/Reset is possible depending on a condition.)
  • You can check the current location and each setup value of the robot.
  • You can check and register variables.
  • You can check the error codes and descriptions.
  • You can check the system version of the controller.

How to Install

These download files are self-extracting files.
Double-click on the file to open a sample file and the PDF file of an explanatory material.

Download file

Sample File
2.41 MB (2,528,199 Byte)

Terms of use / Cautions

Please acknowledge the following terms of use before you use our download service.
Download of any file signifies your agreement to the terms of use.
Terms and conditions