VARAN Slave - Version V1.1.0.0
=========================================
** Bug
    * [PSVRS-47] - Sync OUT0 pulse polarity toggles
    * [PSVRS-62] - Errors of command RCX_DPM_GET_COMMON_STATE_REQ/_CNF
    * [PSVRS-82] - Min distance between 2 Sync Out signals is 80 ns
    * [PSVRS-88] - VARAN_CLIENT_PCK_EVENT_IND can not be received
    * [PSVRS-102] - Output memory area nulled, when an empty SetInput request is sent
    * [PSVRS-103] - FW does not take over Bustype (PCI/DPM) from Bootloader (causes high CPU load on PC)
    * [PSVRS-104] - Text corrections in VRS_Diag.xml
    * [PSVRS-105] - Connection timeout immediately after setting BUS_ON flag
    * [PSVRS-109] - VARANApp incorrect Extended Diag
    * [PSVRS-110] - Wrong network state when bus flag is off
    * [PSVRS-111] - RUN flag remains set after Watchdog timeout
    * [PSVRS-113] - Incorrect network state after wtachdog event
    * [PSVRS-115] - A Communication error is not cleared after configuration download
    * [PSVRS-116] - Wrong behavior with latest Sigmatec VARAN Manager
    * [PSVRS-131] - netX51 firmware has incorrect tags size

** Change
    * [PSVRS-108] - change ERR led behaviour in case of comm. error
    * [PSVRS-118] - Adapt to WAF V1.8.3.0
    * [PSVRS-119] - Removing tabs and whitespaces
    * [PSVRS-126] - HAL update V1.4.0.0
    * [PSVRS-127] - Support rcXV2.1.11.9 / Diag&RemoteAccess V2.0.17.1
    * [PSVRS-128] - All targets should be ported to rcXV2.1
    * [PSVRS-129] - Flash Label support for netx51/52 and netRapid firmwares
    * [PSVRS-130] - Enable marshaller for netX52 and netRapid52

** New Feature
    * [PSVRS-112] - Bus Watchdog timeout to be reported via ERR led
    * [PSVRS-121] - New target netX51 supported
    * [PSVRS-123] - New target netRAPID52 supported
    * [PSVRS-124] - New target netX52 supported

    
VARAN Slave - V1.0.8.0
=========================================
- 0017453: [Firmware] FW does not take over Bustype (PCI/DPM) from Bootloader 
- 0015554: [Firmware] VARAN_CLIENT_PCK_EVENT_IND can not be received
- 0017219: [Firmware] Output memory area nulled, when an empty SetInput request is sent

VARAN Slave - V1.0.7.0
=========================================
- 0017015: [Firmware] NJ50 - Undescribed led flashes permanetly ON 
- 0017014: [Firmware] Unexpected Led's behaviour for NJ100 and NJ50 
- 0015536: [Firmware] DPM not cleared after the cable is disconnected 
- 0017037: [Firmware] When watchdog is triggered, invalid communication error is displayed 
- 0017031: [Firmware] ChangeState diagnostic counters not incremented properly 
- 0017029: [Firmware] SetWatchdog request must return standart rcX error, in case invalid argument is encountered 
- 0017033: [Firmware] After delete configuration and a following channel init, RUN flag is cleared 

VARAN Slave - V1.0.6.0 
=========================================
- 0016038: [Firmware] Reserved Values in VRS_Diag.xml visible. 
- 0015913: [Firmware] Wrong DPM size for COMX module
- 0015872: [Firmware] [NJ 50XX RE/VNS] The USB diagnostic interface doesn't work. 
- 0015554: [Firmware] VARAN_CLIENT_PCK_EVENT_IND can not be received 
- 0015536: [Firmware] DPM not cleared after the cable is disconnected 
- 0015555: [Firmware] Unexpected behavior when Config. lock flag is set 

VARAN Slave - V1.0.5.0
=========================================
- 0015133: [Firmware] New fimware netJACK 50/100 supported.
- 0013089: [Firmware] Errors in ReleaseNotes
- 0013088: [Firmware] Include folder
- 0013272: [Firmware] Extended diagnostic for the configuration should be implemented
- 0014132: [Firmware] Data is not exchanged between DPM and bus in some configurations
- 0014110: [Firmware] Cyclic communication without configuration
- 0014108: [Firmware] Wrong error code on Channel Init without configuration
- 0014111: [Firmware] VARAN_CLIENT_CMD_RESET_REQ not always possible

VARAN Slave - V1.0.4.0
=========================================
- 0014083: [Firmware] Old data is sent when writing data in DMA mode 
- 0014104: [Firmware] Host watchdog value 0 not supported 
- 0014082: [Firmware] Communication class in NXF header different to DPM 
- 0014107: [Firmware] Spelling errors in VARANStack_Public.h 
- 0014113: [Firmware] NXHX50 is not accessible through serial interface 
- 0014103: [Firmware] Error codes equal to Componet Slave 
- 0014115: [Firmware] No LED indication on NXHX50 
- 0014149: [Firmware] No SyncOut signal on NXHX50 
- 0014114: [Firmware] NXHX50 hangs on System Reset 

VARAN Slave - V1.0.3.0
======================
- 0013337: [Firmware] Wrong parameter use in command RCX_LOCK_UNLOCK_CONFIG 
- 0013332: [Firmware] Command RCX_DELETE_CONFIG should not inhibit a following 'Channel Init' 
- 0013333: [Firmware] 'Channel Init' is rejected after System Start 
- 0013297: [Firmware] Wrong lengths of packets VARAN_CLIENT_CMD_INIT_REQ/VARAN_CLIENT_CMD_CHECK_CFG_REQ accepted 
- 0013313: [Firmware] Wrong handling of RCX_UNREGISTER_APP_REQ/_CNF command 
- 0013302: [Firmware] Inconsistent counters in command VARAN_CLIENT_CMD_GET_DIAG_CNF 
- 0013296: [Firmware] Command VARAN_CLIENT_CMD_CHANGE_STATE_REQ has no effect
- 0013284: [Firmware] Wrong confirmation packet VARAN_CLIENT_PCK_INIT_CNF
- 0013282: [Firmware] Wrong Data state of command VARAN_CLIENT_PCK_GET_OUTPUT_CNF
- 0013279: [Firmware] Errors of command VARAN_CLIENT_CMD_SET_INPUT_REQ 
- 0013210: [Firmware] USB not working on CIFX 104C 
- 0012398: [Firmware] Start of NXO module fails
- 0013192: [Firmware] USB Diag and TagList support.
- 0013145: [Firmware] Client watchdog time has no effect 
- 0012391: [Firmware] Sync OUT0 Polarity inverted and no effect. 
- 0013153: [Firmware] Errors of command VARAN_CLIENT_APP_CMD_SET_CONFIGURATION_REQ 
- 0012990: [Firmware] Correct the firmware distribution folder names 
- 0013187: [Firmware] netX100 + comX FW distribution. 
- 0013188: [Firmware] Wrong device class set for netX50/100/500 FW 
- 0013085: [Firmware] Wrong special characters in VRS_Diag.xml 
- 0013005: [Firmware] Wrong 'netX Status Flags' in Dualport-memory
- 0013067: [Firmware] Communication and Protocol Class not set in DPM
- 0012981: [Firmware] Wrong confirmation packet length of command VARAN_CLIENT_APP_CMD_SET_CONFIGURATION_REQ 
- 0012983: [Firmware] Channel Init is accepted in Config Locked state 
- 0012984: [Firmware] Set Watchdog time is accepted in Config Locked state 

VARAN Slave - V1.0.2.0
======================
- 0013175: [Firmware] Trivial changes - include files restructurred (dlyutskanov)

VARAN Slave - V1.0.1.0
======================
- 0012476: [Firmware] Support DMA mode for CIFX
- 0012398: [Firmware] Start of NXO module fails
- 0012470: [Firmware] Sync Puls length by 1 or 4 bigger than configured
- 0012388: [Firmware] Wrong DPM IO information 
- 0012429: [Firmware] Memory area 2 not functional
- 0012428: [Firmware] IO data not handled completely with different Read and Write size 
- 0012399: [Firmware] nx500 shows no files in file explorer 
- 0012400: [Firmware] DPM access fails in 16-bit mode 
- 0012455: [Firmware] Report communication error in common status 
- 0012401: [Firmware] Wrong LEDs are used on NXHX500 
- 0012390: [Firmware] RE STAUS Led an NXHX50 is always RED. 
- 0012417: [Firmware] nx50 fails after Bus On with controlled communication start 
- 0012447: [Firmware] Cyclic communication continues on host watchdog error 
- 0012441: [Firmware] Com flag set without cyclic communication 
- 0012389: [Firmware] No LED Description.
- 0012444: [Firmware] ulMemArea not checked by VARAN_CLIENT_CMD_GET_OUTPUT_REQ 
- 0012392: [Firmware] Sync OUT0 Enable/Disable does not work. 
- 0012391: [Firmware] Sync OUT0 Polarity inverted and no effect. 
- 0012381: [Firmware] Channel Init times out when already configured
- 0012430: [Firmware] VARAN_CLIENT_CMD_SET_INPUT_REQ fails 
- 0012397: [Firmware] Drv_PhyInitialisation not in parallel with XC code loading
- 0012404: [Firmware] cifX Slot number is lost after System Start 
- 0012412: [Firmware] Corrections in VARANStack_Public.h 
- 0012383: [Firmware] Missing Diag structure definitions 
- 0012396: [Firmware] GetWatchdog diag counter increased 2 times 
- 0012380: [Firmware] Exchanged Build and Revision numbers in nxf header 
- 0012385: [Firmware] RCX_START_STOP_COMM_REQ uses wrong parameter for stop 
- 0012379: [Firmware] Correct firmware file names 
- 0012395: [Firmware] VRS_Diag.xml corrections 

V0.9.0.0
--------
 - First Beta Build
 - Adapted to nAnt building environment
 - Added all corresponding targets