


=====================================================================
Description: Windows NT4.0 generic backpack Installation Instructions
=====================================================================
File: Ntreadme.txt (For LPG1 boards)
=====================================================================
Product: 3300 series and 1401 products with an LPG1 motherboard.
=====================================================================
Extra Hardware required:
     1. External Xycom Floppy drive
     2. Backpack CD-Rom drive from Micro-solutions or equivalent.
     3. Boot floppies.
=====================================================================
Instructions:
* Create the 3 disk set for Windows NT. The instructions are referred
  to in Xycoms file 140298(x) Windows NT Recovery Media
  Installation.pdf (x represents file rev.) located on the Xycom
  Documentation CD.
* Place the recovery CD in the Backpack CD-Rom .
* Start the system with the NT boot disk #1 in the floppy drive.
* Follow the normal install process until asked to detect IDE
  devices. At this point, press "S" to skip the auto detect.
* Now press "S" to specify additional devices. When prompted for the
  third party driver disk, use the special NT backpack driver disk.
  This can be acquired from the Xycom Support group.
* After that, press the "Enter" key  to continue. 
* Finish the normal installation. 
* Copy the NT drivers from the Xycom Document CD to the c: drive.
* Install the VGA/System driver that was found on the Xycom Document
  CD. Follow the video driver installation instructions (found in the
  Workstation recovery Instructions mentioned above) and the special
  instructions in the "readme.txt" file that is supplied with this
  driver.
* Install the LAN driver found on the Xycom Document CD (if needed).
* Install any Service packs (if needed).
=====================================================================

