


=====================================================================
Description: Windows 2K generic backpack Installation Instructions
=====================================================================
File: 2Kreadme.txt (For LPG1 boards)
=====================================================================
Product: 3300 series and 1401 products with an LPG1 motherboard.
=====================================================================
Extra Hardware required:
     1. External Xycom Floppy drive
     2. Backpack CD-Rom drive from Micro-solutions or equivalent.
     3. Boot floppies.
=====================================================================
Instructions:
* Using instructions referred to in the 140639(x) Windows 2000
  Recovery Media Installation.pdf file, create the 4 disk set for
  Windows 2000 (x=Rev of the instruction file).
* Place the recovery CD in the Backpack CD-Rom .
* Start the system with the Windows 2000 boot disk #1 in the floppy
  drive.
* When the message at the bottom of the screen says "Press F6 to load
  SCSI or 3rd party drivers" You MUST press F6.
  Warning: This message will disappear in a short amount of time.
  If you did not press F6, the installation will eventually fail
  during disk #4. The install process will have to be restarted.
* Follow the normal install process until asked to specify additional
  devices.
* Now press "S" to specify additional devices. When prompted for the
  third party driver disk, use the Windows Backpack driver disk. 
* After that, press the "Enter" key to continue. 
* Continue the normal installation until prompted to insert the
  Backpack floppy disk. Place it in the floppy drive and press the
  "Enter" key.
* Continue the installation.
* After the installation is complete, copy the I386 directory to the
  hard drive. This will simplify driver installs in the future.
* Copy the 2000/XP drivers from the Xycom Document CD to the c:
  drive.
* Install the System driver that was found on the Xycom Document CD. 
* Install the Video driver that was found on the Xycom Document CD. 
* Install the LAN driver found on the Xycom Document CD (if needed).
* Install any Service packs (if needed).
* The device manager with show a Yellow exclamation mark for the
  Multimedia Audio Controller. If this presents a problem, follow
  the areadme.txt file (found on the Xycom Document CD) for
  instructions on how to clear that warning.
=====================================================================
