Device/PLC Communication Settings
Click here to see this page in full context

7.1 Settings Menu

Connecting to Multiple Devices/PLCs

Overview 7.2 Connecting to Multiple Devices/PLCs

Steps 7.2.1 Procedure - Connecting to Multiple Devices/PLCs

 

Disconnecting Multiple Connected Devices/PLCs

Overview 7.3 Disconnecting Multiple Connected Devices/PLCs

Steps 7.3.1 Procedure - Stop Communications

Steps 7.3.2 Procedure - Confirming the Communication State

To stop the display unit from scanning for a device/PLC, set the communication bit to OFF.

 

Changing a Device/PLC

Overview 7.4 Changing a Device/PLC

Steps 7.4.1 Procedure - Converting the PLC type without designating an Address Conversion Range

Steps 7.4.2 Procedure - Converting the PLC type and designating an Address Conversion Range

 

Changing the Device/PLC at Runtime (Indirect Device)

Overview 7.5 Changing the Device/PLC at Runtime (Indirect Device)

Steps 7.5.1 Procedure - Changing the Device/PLC at Runtime (Indirect Device)

Change a connected device without changing a screen.

 

Connecting Multiple Display Units to One Device/PLC (Ethernet Multilink)

Overview 7.6 Connecting Multiple Display Units to One Device/PLC (Ethernet Multilink)

Steps 7.6.1 Procedure - Connecting Multiple Display Units to One Device/PLC (Ethernet Multilink)

Steps 7.6.2 Procedure - How to Calculate the Communication Traffic

 

Preventing Operations from Other Display Units (Ethernet Multilink)

Overview 7.7 Preventing Operations from Other Display Units (Ethernet Multilink)

Steps 7.7.1 Procedure - Preventing Operations from Other Display Units (Ethernet Multilink)

 

Using Device/PLC Tags

Overview 7.8 Using Device/PLC Tags

Steps 7.8.1 Procedure - Using Device/PLC Tags