23.14.2 Operation Log Contents, Example Output

Number	Date	Time	User ID	LEVEL	Screen	Parts ID	Comment	Action	Address	IP Adress
1	07/12/22	13:54		0	B1	SL_0001		Bit Set	[PLC1]M0000
2	07/12/22	13:54		0	B1	SL_0002		Bit Rst	[PLC1]M0001
3	07/12/22	1:55 PM	YAMADA	3	B1	SL_0003	Level 3 Switch	Bit Mom		192.168.0.1

Items	Description
Number	Log number
Date	Operation data is displayed in the format that is set in [Operation Log Settings].
Time	Operation time is displayed in the format that is set in [Operation Log Settings].
User ID	User ID that is registered in [User ID Mode] (Add User ID) is displayed. For [Level Mode] (Do not add User ID), this will be blank.
LEVEL	Display the level between 0 to 15 at the time of operation.
Screen	Displays the Screen Number as B for Base Screens, and W for Window Screens, at the time of operation.
Parts ID	Displays the Parts ID.
Comment	Displays comments in Parts. If nothing is registered, this will be blank.
Action	Displays the action. 23.14.1 Operations To Log
Address	Displays a target address.
IP Address	When using Pro-face Remote HMI to operate the display unit screen, displays the client IP address. To display the IP address, from the [Common Settings] click [Operation Log Settings], then select the [Add IP address to log when operating from Pro-face Remote HMI] check box. 23.10.2 Operation Log Settings
Sub Info	Address, Action. Sub Info displays when supplemental remarks are needed for the Address or Action.
Prev Value	Displays the previous value.
Chg Value	Displays the changed value. Bit Address displays ON or OFF, Word Address displays a numeric value. The display format of the numeric value differs depends on the display attributes of the parts being used.
Added Info	When recording the operation log, values stored in the specified word addresses will be read. Stores values only when setting up from the [Common Settings] menu's [Operation Log Settings]. 23.10.2 Operation Log Settings In the following cases, values are not acquired. Instead they will be shown as "****". When reading word address values failed When invalid addresses or symbols are defined in the Trigger Monitor word address. When trigger bit was not turned ON when trigger monitor is set. When the display format is set to BCD and illegal values are stored, data values stored in word addresses are converted and displayed. When using Indirect Device addresses, instead of the indirect device name, displays the device/PLC name specified by the Device ID. If a Device ID that does not exist is specified, displays questions marks "????".